Brewery Pumps

Brewing is hard on pumps. Liquids run hot, they carry grain and hop matter, and the whole system gets cleaned with caustic on a regular basis, which rules out a lot of general purpose kit straight away. This category brings together the centrifugal pumps we recommend for brewery duty, drawn from Enviroflex, Lowara and Ebara, so you are choosing from a shortlist that already suits the job rather than sifting the whole catalogue.

Stainless Throughout, Sealed For Wort

Everything here is stainless steel construction with stainless impellers, which is non negotiable once you are moving product rather than utility water. Seal selection matters just as much, and hard faced mechanical seals are the ones to specify for wort transfer and clean in place duty, where a standard seal will not last. Impeller design varies across the range too, with closed impellers suiting clean liquids and open or semi open designs handling the suspended solids that come with grain and hops.

Connections And Configurations

Both BSP threaded and Tri-Clamp connections run through the range, so you can match existing brewery pipework or specify hygienic fittings for product contact. Sizes span from inch and a quarter up to 3 inch, in single phase 230v and three phase 400v, covering everything from a small craft setup to a commercial brewhouse. Self priming options are available where the pump sits above the vessel it is drawing from.